Illustrated guide to help install a motherboard
You are now in a position to install the CPU and RAM in your new motherboard, before fitting it into the case. First, take your CPU and locate the marker on one corner. Line this up with the marker on the socket on the motherboard and drop the CPU into place. Push down the metal lever arm to lock the CPU into place.
If necessary, apply a small amount of thermal paste to the top of the CPU and place the heatsink and fan assembly on top. Lock it in place by pushing the level arm fully down, or by locking the metal clip down to the plastic base using a flat-bladed screwdriver. This will require significant force, so apply pressure gently at first and increase until the heatsink locks into place.
Next, install the RAM modules by lining them up with the appropriate slots on the motherboard and pushing down firmly. If the module is sat correctly, the white clips will lock in the upright position, holding the RAM securely.
If you are replacing your motherboard, you may not need to screw any nuts into the case to support the motherboard. If you are installing into a new case, you will need to screw nuts into the case as shown in the photograph. These are needed to screw the motherboard to the case, so you will need to ensure that they are located where there are metal-ringed holes in the motherboard.
Next, slot the motherboard into the case and ensure that the back plate lines up with the back of the case. You may need to manoeuvre the motherboard a little to get the screw holes to line up. Once in place, secure the motherboard to the case using the screws provided.
Plug in any cables from the front panel, power supply or system fans. Refer to your motherboard manual to locate the appropriate pins for these if you are unsure.
Now, replace any drives or expansion cards, such as graphics, sound and network cards.
Slide them one by one into their respective slots and fasten down to the case securely.
Finally, plug in any data or power cables to drives or expansion cards. Make sure you have seated the cables in the appropriate channels and that all the plugs are firmly secured.
Plug your machine in and boot it up. Ideally you should reinstall your operating system, though this is not always essential. Install any motherboard drivers using the CD provided with your motherboard. If everything is working correctly, all your drives and cards should be recognised.
If you have any problems, you should consult your motherboard manual. Your first port of call is to check all the connections and ensure that everything is plugged in. It is also possible you will need to reinstall Windows, though this should be done with caution if you haven't got a full back up of all your data.
